Double-deck - Tillig Modellbahnen

Subsequent installations of contacts for the lighting of H0 double deck coach:

The bogie frame of the double-decker carriages are prepared for the installation of contacts. However, the intended contacts no longer form part of the range due to their insufficient functionality.

However, you have the option of assembling the contacts used in the control car without much effort. When doing this make sure that the double decker carriages have two different bogie mounting points. One bogie has 1 point of contact and one bogie has 2 points of contact.

The installation of the contacts is only possible for a bogey with a single point mounting. In this way it will become necessary to mount both contacts in a bogie and not as is normally the case with both bogies to have the current drawn from the bogies.

Installation of the contacts:

1. Disassemble the bogey, remove wheel sets.

2. Remove the bolt at the lower side of the bogie frame:

3. Produce boreholes with a diameter of 2.5 mm instead of the bolts:

4. Mount two contacts (Article 398630):

5. Install the wheel sets, align the contacts and solder on the wires:

Solder the wire to the grinder departing from the side. This prevents the wire looping on the underbody and a short circuit from occurring.

6. Guide the wire through longitudinal recess into the wagon’s interior. Mount the bogies.

Download here

Switchable train destination sign on H0 double-decker controlling carriage:

The model is equipped with a digital interface for the controlling carriage lighting according to NEM 652. This interface is immediately attached to the rear wall driver’s cab and becomes accessible following removal of the wagon body. The upper part is snapped on to the lower part in the area next to the entrance doors.

The train destination sign on the H0 double-decker controlling carriage (e.g. item no. 73774, 74199) is always active upon production at the factory.

This can be switched off by soldering the resistor (see picture, marked with a circle) and soldering a wire of a function decoder (NEM 652) to the solder pad (see picture, marked with arrow). The train destination sign can then be separately switched on using such a function decoder.

Jumpers:

On the circuit board two jumpers are attached, with which the tail lights can be switched off individually by pulling the respective jumper.

Assignment of interface:

The configuration of the contacts and assignment of the cable colours for the configuration of the interface can be found here.

Download here

(Illustration shows interface with attached pin / socket strips (grid 2.54 pin approx 0.5 mm)

TILLIG Modellbahnen GmbH | Promenade 1 | 01855 Sebnitz

Tel.: +49 (0)35971 903-0 | Fax: +49 (0)35971 903-19 | E-Mail: info@tillig.com

Cookie-Einstellungen